Precise determination of muon and electromagnetic shower contents from shower universality property

We consider two new aspects of Extensive Air Shower development universality allowing to make accurate estimation of muon and electromagnetic (EM) shower contents in two independent ways. In the first case, to get muon (or EM) signal in water Cherenkov tanks or in scintillator detectors it is enough to know the vertical depth of shower maximum and the total signal in the ground detector. In the second case, the EM signal can be calculated from the primary particle energy and the zenith angle. In both cases the parametrizations of muon and EM signals are almost independent on primary particle nature, energy and zenith angle. Implications of the considered properties for mass composition and hadronic interaction studies are briefly discussed. The present study is performed on 28000 of proton, oxygen and iron showers, generated with CORSIKA 6.735 for $E^{-1}$ spectrum in the energy range log(E/eV)=18.5-20.0 and uniformly distributed in cos^2(theta) in zenith angle interval theta=0-65 degrees for QGSJET II/Fluka interaction models.Comment: Submitted to Phys. Rev.

The analog signal processing board for the HEAT telescopes

Abstract The aim of the Pierre Auger Observatory is to measure with high statistics the flux, the arrival directions and the mass composition of cosmic rays at the highest energies. Since 2009, the Auger Collaboration has added three new High Elevation Auger Telescopes (HEAT) along with a new 25 km 2 infill array in the field of view of the new telescopes. These enhancements have lowered the energy threshold of the Observatory by about an order of magnitude. In combination with the existing telescopes in Coihueco the vertical field of view is extended to about 60°, allowing the measurement of nearby air showers arising from primaries with energies as low as 2×10 17 eV. In this paper we describe the new front-end analog board developed to process the signals generated by the photomultipliers of the HEAT telescopes. Eighty analog boards have been produced, fully characterized and tested. The main characteristics of the electronic circuits and the circuit parameters are illustrated

The Central Laser Facility at the Pierre Auger Observatory

The Central Laser Facility is located near the middle of the Pierre Auger Observatory in Argentina. It features a UV laser and optics that direct a beam of calibrated pulsed light into the sky. Light scattered from this beam produces tracks in the Auger optical detectors which normally record nitrogen fluorescence tracks from cosmic ray air showers. The Central Laser Facility provides a "test beam" to investigate properties of the atmosphere and the fluorescence detectors. The laser can send light via optical fiber simultaneously to the nearest surface detector tank for hybrid timing analyses. We describe the facility and show some examples of its many uses.Comment: 4 pages, 5 figures, submitted to 29th ICRC Pune Indi

The arcade project

The Atmospheric Research for Climate and Astroparticle Detection (ARCADE) project aims to a better comprehension of the limits of applicability, systematics and possible enhancements of the typical techniques used for the measurement of the aerosol attenuation profiles of UV light in cosmic rays and gamma rays experiments. Aerosols are indeed the most variable component in the atmosphere on a short time scale, and experiments based on the detection of the UV light in atmosphere need a continuous monitoring of the aerosol stratification to obtain a reliable evaluation of the properties of the primary particles. The ARCADE project is measuring the aerosol attenuation of UV light due to aerosols with multiple techniques and instruments simultaneously on the same air mass. For this purpose, a Raman + elastic Lidar with a laser source at 355 nm has been built and is currently taking data in Lamar, Colorado together with the Atmospheric Monitoring Telescope (AMT) to detect UV light at a distance of 40 km from the Lidar laser source. The system has been installed on site in 2014 and data were taken every month during moonless nights for one year. A full simulation of the AMT system has been developed. The setup and simulation of the system, together with the AMT calibration system and first collected data are shown

Perturbation theory and the two-level approximation:A corollary and critique

This analysis addresses the use of a two-level approximation to simplify expressions derived from perturbation theory. It is shown that the limitations of validity for the emergent results are more stringent than is commonly understood, being equivalent in effect to the adoption of a more extensive approximation - one that significantly undermines the perturbative origin of those expressions. Effectively truncating the completeness relation, a series of interconnected operator relations comes into play, some with physically untenable consequences. A new theorem on the expectation values of operator functions highlights additional constraints upon any molecule modelled as a two-level system. © 2010 Elsevier B.V. All rights reserved

Measurement of Aerosols at the Pierre Auger Observatory

The air fluorescence detectors (FDs) of the Pierre Auger Observatory are vital for the determination of the air shower energy scale. To compensate for variations in atmospheric conditions that affect the energy measurement, the Observatory operates an array of monitoring instruments to record hourly atmospheric conditions across the detector site, an area exceeding 3,000 square km. This paper presents results from four instruments used to characterize the aerosol component of the atmosphere: the Central Laser Facility (CLF), which provides the FDs with calibrated laser shots; the scanning backscatter lidars, which operate at three FD sites; the Aerosol Phase Function monitors (APFs), which measure the aerosol scattering cross section at two FD locations; and the Horizontal Attenuation Monitor (HAM), which measures the wavelength dependence of aerosol attenuation.Comment: Contribution to the 30th International Cosmic Ray Conference, Merida Mexico, July 2007; 4 pages, 4 figure

New developments in aerosol measurements using stellar photometry

The idea of using stellar photometry for atmospheric monitoring for optical experiments in highenergy astrophysics is seemingly straightforward, but reaching high precision of the order of 0.01 in the determination of the vertical aerosol optical depth (VAOD) has proven difficult. Wide-field photometry over a large span of altitudes allows a fast determination of VAOD independently of the absolute calibration of the system, while providing this calibration as a useful by-product. Using several years of data taken by the FRAM (F/(Ph)otometric Robotic Atmospheric Monitor) telescope at the Pierre Auger Observatory in Argentina and about a year of data taken by a similar instrument deployed at the planned future Southern site of the Cherenkov Telescope Array in Chile, we have developed methods to improve the precision of this measurement technique towards and possibly beyond the 0.01 mark. Detailed laboratory measurements of the response of the whole system to both the spectrum and intensity of incoming light have proven indispensable in this analysis as the usual assumption of linearity of the CCD detectors is not valid anymore for the conditions of the observations